同步操作将从 ApolloAuto/apollo 强制同步,此操作会覆盖自 Fork 仓库以来所做的任何修改,且无法恢复!!!
确定后同步将在后台操作,完成时将刷新页面,请耐心等待。
The following guide serves as a user manual for launching the Apollo upgraded software and hardware stack on vehicle, which is similar to Apollo 5.5.
This Quick Start Guide focuses on the new features. For general Apollo concepts, please refer to Apollo 5.5 Quick Start
Apollo currently integrates emergency vehicle detection through audio devices. Microphones are installed on the vehicle to collect audio signals around the autonomous vehicle, and the recorded soundtracks will be analized and processed to detect emergency vehicles in the surroundings. The module detail is here.
Apollo integrates new deep learning models including obstacle detection with PointPillars, pedestrian prediction with semantic map and learning based trajectory planning. Please find details in corresponding modules
The Hardware setup for Apollo 6.0 remains the same as Apollo 3.5, please refer to Apollo 3.5 Hardware and System Installation Guide for the steps to install the hardware components and the system software, as well as Apollo Software Installation Guide.
For questions regarding Dreamview icons refer to the Dreamview Usage Table. For questions regarding Dreamland and the scenario editor, please visit our Dreamland Introduction guide
Plug-in an external hard-drive to any available USB port in the host machine
Turn on the vehicle, and then the host machine
Launch the Dev Docker Container
Launch DreamView
Open URL http://localhost:8888 to launch Dreamview web service onyour host
Select Mode, Vehicle and Map
Note: You'll be required to setup profile before doing anything else. Click the dropdown menu to select Navigation mode, the HDMap and vehicle you want to use. The lists are defined in HMI config file
Note: It's also possible to change the profile on the right panel of the
HMI, but just remember to click Reset All
on the top-right corner to
restart the system
Start the Modules.
Click the Setup
button
Go to Module Controller tab, check if all modules and hardware are ready (Note: In your offline environment, the hardware modules such as GPS, CANBus, Velodyne, Camera and Radar cannot be brought up) (Note: You may need to drive around a bit to get a good GPS signal)
Under Default Routing
select your desired route
Under Tasks click Start Auto
. (Note: Be cautious when starting the autonomous
driving, you should now be in autonomous mode)
After the autonomous testing is complete, under Tasks
click Reset All
, close all
windows and shutdown the machine
Remove the hard drive
此处可能存在不合适展示的内容,页面不予展示。您可通过相关编辑功能自查并修改。
如您确认内容无涉及 不当用语 / 纯广告导流 / 暴力 / 低俗色情 / 侵权 / 盗版 / 虚假 / 无价值内容或违法国家有关法律法规的内容,可点击提交进行申诉,我们将尽快为您处理。