UART Usage Example

#include "hdf_log.h"
#include "uart_if.h"

void UartTestSample(void)
{
    int32_t ret;
    uint32_t port;  
    DevHandle handle = NULL;
    uint8_t wbuff[5] = { 1, 2, 3, 4, 5 };
    uint8_t rbuff[5] = { 0 };
    struct UartAttribute attribute;
    attribute.dataBits = UART_ATTR_DATABIT_7;   /* Set the number of data bits to 7. */
    attribute.parity = UART_ATTR_PARITY_NONE;   /* Set the parity bit to no parity. */
    attribute.stopBits = UART_ATTR_STOPBIT_1;   /* Set the stop bit to 1. */
    attribute.rts = UART_ATTR_RTS_DIS;          /* Disable the RTS signal. */
    attribute.cts = UART_ATTR_CTS_DIS;          /* Disable the CTS signal. */
    attribute.fifoRxEn = UART_ATTR_RX_FIFO_EN;  /* Enable RX FIFO. */
    attribute.fifoTxEn = UART_ATTR_TX_FIFO_EN;  /* Enable TX FIFO. */
    /* Set the UART port number actually used. */
    port = 1; 
    /* Obtain the UART device handle. */
    handle = UartOpen(port);
    if (handle == NULL) {
        HDF_LOGE("UartOpen: failed!\n");
        return;
    }
    /* Set the UART baud rate to 9600. */
    ret = UartSetBaud(handle, 9600);
    if (ret != 0) {
        HDF_LOGE("UartSetBaud: failed, ret %d\n", ret);
        goto _ERR;
    }
    /* Set the UART device attributes. */
    ret = UartSetAttribute(handle, &attribute);
    if (ret != 0) {
        HDF_LOGE("UartSetAttribute: failed, ret %d\n", ret);
        goto _ERR;
    }
    /* Set the UART transmission mode to non-blocking mode. */
    ret = UartSetTransMode(handle, UART_MODE_RD_NONBLOCK);
    if (ret != 0) {
        HDF_LOGE("UartSetTransMode: failed, ret %d\n", ret);
        goto _ERR;
    }
    /* Write 5-byte data into the UART device. */
    ret = UartWrite(handle, wbuff, 5);
    if (ret != 0) {
        HDF_LOGE("UartWrite: failed, ret %d\n", ret);
        goto _ERR;
    }
    /* Read 5-byte data from the UART device. */
    ret = UartRead(handle, rbuff, 5);
    if (ret < 0) {
        HDF_LOGE("UartRead: failed, ret %d\n", ret);
        goto _ERR;
    }
_ERR:
    /* Destroy the UART device handle. */
    UartClose(handle); 
}