This action will force synchronization from ApolloAuto/apollo, which will overwrite any changes that you have made since you forked the repository, and can not be recovered!!!
Synchronous operation will process in the background and will refresh the page when finishing processing. Please be patient.
The following guide serves as a user manual for launching the Apollo upgraded software and hardware stack on vehicle.
The the latest Apollo upgrade, Quick Start Guide focuses on the new features. For general Apollo concepts, please refer to Apollo 1.0 Quick Start.
For the vehicle's onboard testing make sure you have calibrated all the sensors. For sensor calibration, please refer to Apollo 2.0 Sensor Calibration Guide before you proceed.
For questions regarding Dreamview icons refer to the Dreamview Usage Table.
Plug-in an external hard-drive to any available USB port in the host machine.
Turn on the vehicle, and then the host machine.
Launch Docker Release Container.
Note: Use your favorite browser to access Dreamview web service in your host machine browser with URL http://localhost:8888.
Select Mode, Vehicle and Map.
Note: You'll be required to setup profile before doing anything else. Click the dropdown menu to select Navigation mode, the HDMap and vehicle you want to use. The lists are defined in HMI config file.
Note: It's also possible to change the profile on the right panel of the
HMI, but just remember to click
Reset All on the top-right corner to
restart the system.
Start the Modules.
Go to Module Controller tab, check if all modules and hardware are ready. (Note: In your offline environment, the hardware modules such as GPS, CANBus, Velodyne, Camera and Radar cannot be brought up.) (Note: You may need to drive around a bit to get a good GPS signal.)
Default Routing select your desired route.
Under Tasks click
Start Auto. (Note: Be cautious when starting the autonomous
driving, you should now be in autonomous mode.)
After the autonomous testing is complete, under Tasks click
Reset All, close all
windows and shutdown the machine.
Remove the hard drive.